This Compact Strut Clamp Spreader Tool Allows Suspension Struts and Ball Joints to Be Held Open to Make Removal and Installation Easier On Many Vehicles.
Separates Rusted, Frozen or Seized Dual Wheels on Many Trucks, Buses, Vans, RVs or Trailers.
The Extra Deep 15/16" Works Well on the 30/36 Spring Brakes for Autocar, CCC Style Dump Trucks, and Garbage Trucks with MGM Brakes.
**SUPERSEDED to 41620 Caster Camber Kit for GM, 6 pc.**
The 14-1/2" 21mm Wrench can be Used from Bottom Side of Vehicle to Move Hard-to-Reach and Often Rusty OEM Cams on 1999 and Newer GM Vehicles with Coil Spring Front Suspensions.
The 20% Thicker Fork Design Provides Extra Lift When Replacing Worn Out Ball Joints, Pitman Arms, Pickup Track Bars and Other Applications.
Pneumatic Bushing Driver Set Removes and Installs Truck and Trailer 1-3/8" Anchor Pin Bushings and Stuck Anchor Pins.
L2 Camber Wrench
L1 Camber Wrench
M2 Camber Wrench
M1 Camber Wrench
The Kit Includes 5 Cam Adjusting Holding Tools to Adjust the Control Arm Cams Found on Chevrolet and GMC Vehicles.
Hub Remover Plate.
Threaded Insert.
Washer
Time Saving Tool That Safely Removes Frozen Hub Assemblies Without Damaging Other Suspension Components.
41650 Caster Camber Holding Tool
41640 Caster Camber Wrench, 21mm & 24mm
*SUPERSEDED to 41620 Caster Camber Kit for GM, 6 pc.
The 14-1/2" 21mm/24mm Wrench can be Used to Move Hard-to-Reach and Often Rusty OEM Cams on 1999 and Newer GM 1/2 and 3/4 Ton Vehicles with Coil Spring Front Suspensions.
Improved Socket Design to Work on Longer Applications.
Easily Remove and Install Wheels on Vehicles with Lug Bolts.
Pneumatic Bushing Driver Set Removes and Installs Truck and Trailer 1-3/8" Anchor Pin Bushings and Stuck Anchor Pins.
Works on many applications.
Use with a Pry Bar to Separate the Lower Control Arm from the Ball Joint Stud.
For MacPherson Strut Springs Only.
Special Socket Design Applies the Impact Force to the Center of the Frozen Bolt Through the Nose on the Pneumatic Driver.
Loosens bolts and clamps on tie rods for removal or adjustment.
Works On Inner Tie Rods With Inaccessible Wrench Flats On Many Trucks and SUVs.
40mm Crowfoot for GM for 54500
Works on Inner Tie Rods with Inaccessible Wrench Flats.
For Use on 2002 and Newer Ford SUVs with Independent Rear Suspension.
Removes Inner Tie Rods Equipped with a Completely Round End Socket. Also Fits Inner Tie Rod Sockets with Flats.
Works on Tie Rods With Inaccessible Flats. Includes an Additional 1-1/2"Crows Foot for Chevrolet Colorado and GMC Canyon.
Tough Tool Makes easy Work of 3 Different Jobs.
Disconnects quick connect push-in connectors found on heavy-duty truck air systems and more.
For 2005 and Later Ford F250 & F350.
Heavy Duty Puller Works on Most Cars & Trucks.